Optical Tables
Optical Table Supports 1TS
- Convenient sizes
- Optimal height
- Multipurpose in use
- Handy assembling
- Sturdiness is fit to user specified loads/sizes by doubling the number of beams

Optical Table Supports 1TS are primarily designed for the Honeycomb Table Tops 1HT. Table Supports are produced from steel tubes of 100mm and 80mm square section, in decorative black coating. 1TS is composed of two "H" type supports, bound by a cross-beam.

Optical Table Supports 1TS ideally suit other types of optical plates and other equipment, as well. This is possible because plates are not fastened – they are just laid on top of the supports.

The 1TS Table Supports in stock
Model b,
mm		 l,
mm		 h,
mm		 H***,
mm		 Weight,
kg		 Best for these
tabletops
1TS05-07-05
1TS05-07-06		 500 700 500
600		 810...860
910...960		 48 1HB06-08-07;
1HT08-10-20;
1HT09-14-12
1TS05-12-05
1TS05-12-06		 500 1200 500
600		 810...860
910...960		 53 1HT08-20-20
1TS065-12-05
1TS065-12-06		 650 1200 500
600		 810...860
910...960		 55 1HT10-20-20;
1HT12-24-20
1TS08-12-05
1TS08-12-06		 800 1200 500
600		 810...860
910...960		 58 1HT15-24-20
1TS065-18-05
1TS065-18-06		 650 1800 500
600		 810...860
910...960		 64 1HT12-30-20;
1HT12-35-20
***The heights are measured with table tops 200mm thick and with rubber leveling elements AR.

When ordering, please specify the type of leveling elements.
E.g. 1TS05-12-06-AR means table support 500 mm wide, 1200 mm long and 600 mm high with 8 rubber levelling elements AR.
On request we produce table supports of any size and design.
 Table supports may be supplied with various leveling and vibration-isolation systems. This allows to meet various needs of our customers.


Rubber leveling element (AR) guarantees sufficient vibration isolation. 8 pieces required.


Solid leveling element (AS) is used when no damping is needed. 8 pieces required.


Passive air leveling vibration isolator (AP).
4 pieces of AP are placed on the top side of 1TS, and 4 pieces of AR or AS are placed on the floor.
There are different models of AP with different load capacities.

Deflection "f" is minimal
when the distance between supports
equals 0.554L

 If required, e.g. when used with a laser shelf 1LS51,
the table support may be assembled upside-down.
This doesn’t degrade its performance.

e-mail: sales@standa.lt
http://www.standa.lt